Festool 575306 Kapex KS 120 REB Miter Saw Manual

The Festool 575306 Kapex KS 120 REB is a high-performance miter saw designed for precision cutting in various materials. It features a powerful motor, dual laser guide, and an innovative dust extraction system to keep your workspace clean. Below are key sections for safety, features, installation, setup, operation, and troubleshooting.

1. Features at a Glance 2. Installation 3. First-Time Setup 4. Specifications 5. Controls and Settings 6. Connecting Devices 7. Operating the Miter Saw 8. Maintenance 9. Safety Information 10. Troubleshooting

Features at a Glance

Key components: Powerful motor, dual laser guide, adjustable cutting angles, and integrated dust extraction.

Feature	Description
Powerful motor	Delivers high torque for smooth cutting through various materials.
Dual laser guide	Provides precise cutting lines for accuracy.
Adjustable cutting angles	Allows for miter and bevel cuts up to 60 degrees.
Integrated dust extraction	Minimizes dust and debris for a cleaner workspace.
Lightweight design	Easy to transport and maneuver on job sites.

Installation

Unpack and inspect contents. Ensure a stable and level surface for setup.

Attach the saw to a workbench or stand using the provided mounting brackets.
Connect the dust extraction hose to the saw's outlet.
Plug the saw into a suitable power outlet.

WARNING! Ensure all connections are secure before operating the saw.

First-Time Setup

Power on the saw and follow the setup instructions.

Adjust the cutting angle using the bevel adjustment knob.
Set the laser guide for accurate alignment.
Test the saw with a scrap piece of material.

CAUTION! Always wear safety goggles and hearing protection when operating the saw.

Specifications

Motor Power: 1600 watts.
Blade Diameter: 12 inches.
Cutting Capacity: 120 mm (depth) x 305 mm (width).
Weight: 20.5 kg.
Dust Extraction: Compatible with Festool dust extractors.
Bevel Angle: 0° to 47° left and right.
Miter Angle: 0° to 60° left and right.

Controls and Settings

Access the settings via the control panel located on the front of the saw. Key controls include the power switch, bevel adjustment knob, and miter angle adjustment lever.

Connecting Devices

Connect the saw to a compatible dust extractor for optimal performance.

Ensure the saw is powered off before connecting.
Attach the dust extraction hose to the saw's outlet.
Plug the dust extractor into a power source.

Tip: Regularly check and clean the dust extraction system for efficiency.

Operating the Miter Saw

Follow these steps for safe and effective operation:

Adjust the cutting angle as needed.
Place the material securely against the fence.
Power on the saw and allow it to reach full speed.
Make the cut using a steady motion.
Power off the saw after completing the cut.

WARNING! Keep hands clear of the blade during operation.

Maintenance

Regular maintenance is essential for optimal performance.

Clean the saw after each use to remove dust and debris.
Inspect the blade for wear and replace if necessary.
Check the alignment of the laser guide periodically.

CAUTION! Always unplug the saw before performing maintenance.

Safety Information

Always follow safety guidelines when operating the miter saw.

Wear appropriate personal protective equipment (PPE).
Keep the work area clean and well-lit.
Do not operate the saw if you are tired or under the influence of substances.

Troubleshooting

Symptom	Possible Cause	Corrective Action
Saw does not start	Power connection issue	Check power cord and outlet.
Blade not cutting	Blade dull or misaligned	Inspect and replace or align the blade.
Excessive dust	Dust extraction not connected	Ensure dust extractor is properly connected.
Laser not visible	Battery issue	Replace the battery in the laser unit.

Service: For further assistance, contact Festool customer support.